General Maintenance Instructions

Door and Hardware:

• Lubricate rollers with 30W oil
• Lubricate hinges with aerosol spray lube
• Check all fasteners and tighten as necessary
• Check print on door sections for wear
• Check glazing bead (if used) for fit and function
• Check general operation of doors for overall function inspect trussing, if used, for damage and tighten all fasteners as required

Tracks:

• Check tracks for damage and replace as required
• Tighten all fasteners as required
• Check back hang for rigidity and tighten all fasteners
• Check pull down ropes for wear and replace as required

Spring assembly:

• Inspect cables for signs of wear, replace as required
• Inspect drums for signs of wear, replace as required
• Check door balance, if motor operated disengage motor operator, per the manufactures instructions and operate the door manually
• If spring adjustment is required, contact an experienced garage door installer

Never attempt spring adjustment unless you are experienced in door installation, severe injury could result

• Check all fasteners for tightness
• Lubricate springs with an aerosol type spray lube or a light film of Oil

General:

• Make sure all original warning tags and stickers are still in place and legible
• Inspect perimeter seals for wear and repair or replace as necessary
• If the door is electrically operated refer to the manufacturers instructions for maintenance
• All maintenance should occur annually or every 5000 cycles, whichever comes first (unless noted otherwise)

Important:

All work on these doors should be done by a trained professional, contact your local door supplier. Severe injury or even death could result from improper maintenance techniques.